Just Another Gadget Blog

Breaking

Tuesday, December 8, 2015

Samsung Galaxy J1 J100F firmware/stock rom to unbrick your phone

As promised this is the firmware for Samsung Galaxy J1. This firmware is for J100F Samsung Galaxy J1 variant.

I only copy pasted my post from J100H, because the procedure is just the same.




Hey all, 


Check out this firmware for Samsung Galaxy J1, the firmware is for J100H. There are other variant of J1. An example is J100F. This firmware is only compatible for J100H. 

For other variant of Galaxy J1, I will post it in another article. The file in this post consist of PIT, BOOTLOADER, PDA, MODEM and CSC file.






Download These Files First before proceeding




Odin --> Odin 3.07
Firmware -- > J100FXXU0AOA7 OJV0AOA7 Part 1

Firmware -- > J100FXXU0AOA7 OJV0AOA7 Part 2
Samsung Driver -- > SamsungDriver

"Extract these files in your desired folder"






Installing the driver



1. Install driver first just keep on hitting next. (Open/Execute/Run SamsungDrivePack)
2. After installing the driver Press and Hold Volume Down + Home Key + Power Button, a selection will appear if you would like to go in Download Mode, Press Volume Up to proceed in Download Mode.
3. Connect your phone in the PC via USB Cable
4. Wait for it to finish installing the driver.
"Note: Sometimes it is better to reboot your PC. After installing the driver."



BEFORE PROCEEDING IN FLASHING MAKE SURE  THAT THE BATTERY IS FULLY CHARGED OR 50% CHARGED.



Flashing your Phone
1. Open Odin 3.07
2. Load the file (PDA, Phone, CSC). Click on PDA then look for the firmware that you had extracted. Same with Phone and CSC. Bootloader is optional. 

*** For Rebootloop you can only check PDA, PHONE and CSC. (This is only base on my experience, because flashing PIT is dangerous too. You might brick your phone.)

PIT --> J13G.pit
BOOLOADER --> BOOTLOADER_BL_J100HXXU0AOA1_CL333157_QB3542504_REV01_user_low_ship.tar
PDA --> PDA_AP_J100HXXU0AOA1_CL333157_QB3542504_REV01_user_low_ship.tar.md5
PHONE --> MODEM_CP_J100HXXU0AOA1_CL333157_QB3542504_REV01_user_low_ship.tar.md5
CSC --> CSC_OXE_J100HOXE0AOA1_CL333157_QB3542504_REV01_user_low_ship.tar.md5
Picture is example only.


3. Do not check repartition. 
4. When you are ready to flash your phone, Press and Hold Volume Down + Home Key + Power Button, a selection will appear if you would like to go in Download Mode, Press Volume Up to proceed in Download Mode.
5. Connect your phone in the PC via USB Cable, wait for a value in the ID:COM to appear. It will turn yellow with number example: COM32, if it nothing appear close Odin an open it again and load the file again.
6. Press START to proceed flashing your phone. Wait until it is done, the phone will reboot after flashing.


I hope this tutorial help you. Drop a comment if there is something is not clear to you. Cheers! ^_^

No comments:

Post a Comment

Pages